Spitfire – Maintenance Manual
104
AP-74096, Rev. 1.0, 09/06/05
Step 1 : Remove the 2 screws fixing the cutter holder and holder support.
1 = Holder support 2 = Cutter holder
3 = Screws (M3x6) fixing the cutter holder and holder support
Step 2 : Remove the cutter holder.
Step 3 : Remove the cutter blade and cutter spring from the cutter holder.
Step 4 : Remove the cutter cap and Solenoid spring.
Step 5 : Remove the screw fixing the solenoid assembly to the cutter cap.
1 = Cutter cap 2 = Screws (M3x6) fixing the solenoid assembly to
the cutter cap
3 = Solenoid spring 4 = Solenoid assembly
5 = Screws (M2x4) fixing the solenoid assembly to
the cutter holder
6 = Cutter holder
Step 6 : Replace the cutter cap and solenoid spring.
Step 7 : Remove the 2 screws fixing the solenoid assembly to the cutter holder.
Step 8 : Use a screwdriver to push the solenoid assembly up from the hole on the cutter holder side.
Step 9 : Replace the solenoid assembly.
Step 10 : Reinstall all parts in the opposite order of the removal procedure.
Step 11 : Adjust the cutter according to "Cutter adjustment".
To Next Page
Loading...
