EasyManuals Logo

Navistar INTERNATIONAL DT 466 User Manual

Navistar INTERNATIONAL DT 466
658 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #327 background imageLoading...
Page #327 background image
7 ELECTRONIC CONTROL SYSTEMS DIAGNOSTICS 323
4. If code is active, do step 6 and 7 to check circuit
for the BCP sensor using the following tables:
Circuit Checks for BCP Sensor ECM to
Valve Cover Gasket Connector
Circuit Checks for BCP Sensor ECM to BCP
Sensor
5. If code is inactive, wiggle connectors and wires
at all suspected problem locations. If circuit
continuity is inte rrup ted, the EST will display
DTCs related to the condition.
6. Disconnect engine harness from valve cover
gasket connector.
NOTE: Inspect connectors for damaged pins,
corrosion, or loose pins. Repair if necessary.
7. Connect VC Gasket Breakout H arness to engine
harness only.
EGES-270-1
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.

Table of Contents

Other manuals for Navistar INTERNATIONAL DT 466

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Navistar INTERNATIONAL DT 466 and is the answer not in the manual?

Navistar INTERNATIONAL DT 466 Specifications

General IconGeneral
BrandNavistar
ModelINTERNATIONAL DT 466
CategoryEngine
LanguageEnglish

Related product manuals