7 ELECTRONIC CONTROL SYSTEMS DIAGNOSTICS 337
• When DTC 247 is active the amber ENGINE lamp
will be illuminated.
DTC 546
Engine brake control pressure below expected
range
• DTC 546 is set by the ECM when the brake control
pressure is less than injection control pressure 4
MPa(580psi)formorethan3seconds.
• DTC 546 can be set due to a bias low BCP
sensor or a failed BCP sensor. See “Brake
Control Pressure (BCP) Sensor – Section 7.
• DTC546canbesetduetoanopencontrolcircuit
(power or ground), a failed brake shut-off valve, or
a failed brake shut-off valve solenoid.
• When DTC 546 is active the amber ENGINE lamp
is illuminate d.
DTC 547
Engine brake control pressure above expected
range
• DTC 547 is set by the ECM when the brake
control pressure is greater than desired brake
control pressure by 4.5 MPa (653 psi) for more
than 3 seconds.
• DTC 547 can be set due to an open signal ground,
V
REF
shorted to a voltage source higher than 5.5
V, or a failed BCP sensor. See “Brake Control
Pressure (BCP) Sensor – Section 7.
• DTC 547 can be set due to a control circuit short
to B+ or a brake shut-off valve stuck open.
• When DTC 547 is active the amber ENGINE lamp
is illuminated.
Tools
• EST with MasterDiagnostics® software
• EZ-Tech® interface cable
• Digital Multimeter (DMM)
• VC Gasket Breakout Harness
• 12-Pin Breakout Harness
• 500 Ohm Resistor Harness
• Breakout Box
• Terminal Te st Adapter Kit
EGES-270-1
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
To Next Page
Loading...
Need help?
General