Navistar INTERNATIONAL DT 466 User Manual

582 9 ABBREVIATIONS AND ACRONYMS
NEG – Negative
NETS – Navistar Electronics Technical Support
N•m – Newton meter
NO – Nitrogen Oxide
NO
X
– Nitrogen Oxides
NSBU – Neutral Start Backup Switch
OCC – Output Circuit Check
OL – Over Limit
PID – Parameter Identifier
P/N – Part Number
POS – Positive
POSE – Positive On Shaft Excluder
PROM – Programmable Read Only Memory
psi – Pounds per square inch
pt – Pint
PTO – Power Take Off
RAM – Random Access Memory
rev – Revolution
rpm – Revolutions per minute
ROM – Read Only Memory
RSE – Radiator Shutter Enable
SAE – Society of Automotive Engineers
SCCS – Speed Control Command Switches
SID – Subsystem Identifier
SO
2
– Sulfur Dioxide
SYNC – Sync hronization
TACH – Tachometer output signal
TCAPE – Truck Computer Analysis of Performance
and Econo my
TDC – TopDeadCenter
UVC – Under Valve Cover
V–Volt
V
BAT
– Battery Voltage
V
IGN
– Ignition Voltage
V
REF
– Reference Voltage
V
REF
A–Reference Voltage (e ng in e)
V
REF
B–Reference Voltage (chassis)
VGT – Variable Geometry Turbocharger
VIN – Vehicle Identification Number
VOP – Valve Opening Pressure
VSS – Vehicle Speed Sensor
WIF – Water In Fuel
WTEC – World Transmission Electronically Controlled
automatic transmissions (Allison)
EGES-270-1
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.

Navistar INTERNATIONAL DT 466 Specifications

General

Brand	Navistar
Model	INTERNATIONAL DT 466
Category	Engine
Language	English