4 DIAGNOSTIC/TROUBLESHOOTING MANUAL
• Do not expose batteries to open flames or sparks.
• Do not smoke in workplace.
Compressed Air
• Use an OSHA approved blow gun rated at 207
kPa (30 psi).
• Limit shop air pres s u re to 2 07 kPa (30 p si).
• Wear safety glasses or goggles.
• Wear hearing protection.
• Use shielding to protect others in the work area.
• Do not direct compressed air at body or clothing.
Tools
• Make sure all tools are in good condition.
• Make sure all standard electrical tools are
grounded.
• Check for frayed power cords before using power
tools.
Fluids Under Pressure
• Use extreme caution when working on systems
under press ure.
• Follow approved procedures only.
Fuel
• Do not over fill the fuel tank. Over fill cre ates a fire
hazard.
• Do not smoke in the work area.
• Do not refuel the tank when the engine is running.
Removal of Tools, Parts, and Equipment
• Reinstall a ll safety guards, shie lds , and c overs
after servicing the engine.
• Make sure all tools, parts, and service equipment
are removed from the engine and vehicle after all
work is done.
EGES-270-1
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
To Next Page
Loading...
Need help?
General