NEC Electra Elite 48/192 - Page 163

C - 44 Call Forward – Off-Premise
Issue 6 Electra Elite
1. Lift the handset or press
P
.
2. Dial Access Code
DA
(default).
3. Dial the Trunk Access Code and telephone number where
incoming calls are to be forwarded.
4. Restore the handset or press
P
.
A winking
T
LED indicates the station is in Forward – All Call mode.
- OR -
The Feature Access or One-Touch key LED (when equipped) remains
on while this setting is assigned on the key.
Press Call Forward – All Call ON/OFF key or
T
F I
T
.
1. Lift the handset or press
P
.
2. Dial Access Code
DB
(default).
3. Receive confirmation tone, and restore the handset or press
P
.
1. Press
T
.
2. Dial Access Code
FH
(fixed Access Code).
3. Press
T
.
To set Call Forward – All Call at a Single Line Telephone or a
Multiline Terminal:
To verify Call Forward – All Call (Multiline Terminals only):
To cancel Call Forward – All Call (Multiline Terminal only):
To cancel Call Forward – All Call at a Single Line Telephone or a
Multiline Terminal:
To cancel Forward – All Call, Busy/No Answer, and Do Not
Disturb system-wide (Attendant Positions only):