Features and Specifications Manual F - 1
Facsimile CO Branch
Connection
F-1
FEATURE
DESCRIPTION
The Electra Elite system provides branch connection of locally provided
facsimile machines to CO/PBX lines. Additional dedicated CO/PBX lines are
not required for a facsimile to operate. The facsimile shares the last CO/PBX
line on the COI(4)-U10 ETU, COID(4)-U10, or COIB(4)-U10 ETU through the
Main Distribution Frame (MDF) where the CO line is connected from TELCO.
System Software S2000 or higher is required.
SYSTEM
AVAILABILITY
Terminal Type:
Not Applicable
Required Components:
COI(4)-U10 ETU, COID(4)-U10 ETU, or COIB(4)-U10 ETU
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
COI(4)-U10 ETU, COID(4)-U10 ETU, or COIB(4)-U10 ETU.
Restrictions:
For this feature to work properly using the COIB(4)-U10 ETU, switch
SW400 must be set to Loop Start (LP).
General:
The Electra Elite 48/192 systems require a COI(4)-U10 ETU,
COID(4)-U10 ETU, or COIB(4)-U10 ETU to connect a facsimile in
branch to a direct CO/PBX line.
Connection of the facsimile machine does not require extra system
ports.
None
To Next Page
Loading...