Features and Specifications Manual A - 63
Automatic Day/Night Mode
Switching
A-20
FEATURE
DESCRIPTION
Automatic Day/Night Mode switching programs the system to switch
automatically in or out of the Night Mode at a programmed time. This
eliminates the daily need to manually set/reset the Night Mode. After a
programmed time, the system automatically switches back to Day Mode.
SYSTEM
AVAILABILITY
Terminal type:
Not applicable
Required Components:
None
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-27 (Automatic Day/Night Mode Switching Time
Assignment) to set this assignment for the time of day.
Use Memory Block 1-1-32 (Automatic Day/Night Mode by Day of Week
Selection) to set this assignment for the day of the week.
Two separate Day/Night Mode switch times are available. In any 24 hour
period, the system changes from night mode to day mode at a specified
time, then later the system changes from day mode back to night mode
at a specified time.
Station Code Restriction Class Assignment may also change
automatically when the system goes into Night Mode.
This feature switches Day/Night Mode for all tenants.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
Selection 1] Page 1 LK1 or LK2 to Allow (default: LED On) or Deny (LED
Off) Night Mode Switching system wide or per tenant.
None.
To Next Page
Loading...