Features and Specifications Manual D - 35
Direct Inward Termination (DIT)
D-11
FEATURE
DESCRIPTION
Direct Inward Termination (DIT) allows CO/PBX lines to be programmed to
bypass the Attendant and ring directly at stations or tenants. A separate
Assigned Night Answer (ANA) ringing assignment is available. A System or
Tenant group can be set to the Night Mode independently.
System Software S4000 or higher supports delay ringing to DIT or to DIT
trunks to a tenant.
SYSTEM
AVAILABILITY
Terminal Type
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
CO/PBX lines can be assigned to ring a station number, a hunt group
master number, or an ACD/UCD Pilot number.
Multiple CO/PBX lines can be assigned to ring at the same station, hunt
group master number, or ACD/UCD Pilot number.
Use Memory Block 3-42 (DIT Assignment) to assign Day Mode direct
trunk termination to a station.
Use Memory Block 3-43 (ANA Assignment) to assign Night Mode direct
trunk termination to a station.
Use Memory Block 3-61 (DIT/ANA Delay Answer Time Selection) to
determine the time (default: 0s) an incoming call rings before changing
to a DIT call. System Software S4000 or higher is required.
Use Memory Block 3-62 (DIT Tenant Assignment) to assign a CO/PBX
line to each Tenant. System Software S4000 or higher is required.
No manual operation is required.
To Next Page
Loading...