Features and Specifications Manual E - 25
Emergency 911 - Cut Through
E-7
FEATURE
DESCRIPTION
FEATURE
DESCRIPTION
When all trunks that belong to the Dial Access Code 9 are busy, and a 911 call
is placed, an assigned trunk in the Trunk Group/Route Advance Block is
dropped and accessed again by the system to place the 911 call.
System Software S5500 or higher is required.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
N/A
OPERATING
PROCEDURES
1. Lift the handset or press
P
.
2. Dial
I
AA
or
I
+
IAA
.
3. Talk.
SERVICE
CONDITIONS
Data Assignment
Use Memory Block 1-1-46 [Access Code (1-Digit) Assignment] to Assign
Access Code 9 to access the appropriate Trunk Group or Route
Advance Block.
Use Memory Block 3-69 (911 Cut Through Trunk Selection) to assign
YES to All trunks used for Emergency 911 - Cut Through. Default is all
trunks assigned NO.
Use Memory Block 3-91 (Trunk Type Selection) to assign trunk type to
all trunks used for Emergency 911 - Cut Through. Default is CO.
To use this feature at any terminal:
To Next Page
Loading...