Features and Specifications Manual P - 11
Preset Dialing
P-5
FEATURE
DESCRIPTION
Preset Dialing enables a Multiline Terminal user to originate an outgoing call
by predialing digits on the keypad. After dialing the number, the user can go
off-hook, press the Speaker key, or press a line key to make the call.
System Software S2000 or higher is required.
SYSTEM
AVAILABILITY
Terminal Type:
Any Multiline Terminal
Required Components:
MIFM-U10 ETU with KMM(1.0)U
OPERATING
PROCEDURES
1. Dial the telephone number using the keypad.
2. Go off-hook, or press
P
, or press a CO
W
.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-8-08 [Class of Service (Station) Feature Selection
2] Page 5 LK5 to Allow (LED ON) or Deny (default: LED Off) Preset
Dialing.
Use Memory Block 4-44 (Caller ID Preset Dial Outgoing CO Selection)
to assign the Trunk group, Route Advanced group, or Closed Numbering
group seized for Caller ID outgoing calls.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
MIFM-U10 ETU.
Using a Multiline Terminal:
To Next Page
Loading...