Features and Specifications Manual R- 9
Remote Programming
R-4
FEATURE
DESCRIPTION
Remote Programming is used to modify and save all system parameters from
a remote location using a modem. This is a variation of System Administration
Terminal (SAT) PC Programming, and additional software other than PC
Programming is not required.
SYSTEM
AVAILABILITY
Terminal type:
Not Applicable
Required Components:
PC with SAT PC Programming and modem installed at the remote location.
MIFM-U10 ETU
Modem Kit Unit mounted on the MIFM-U10 ETU or an external modem
connected to the MIFM-U10 ETU through COM1.
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
MIFM-U10 ETU.
General:
The MIFM-U10 ETU must be installed in slot S1 or S2 of the base B64-U10
KSU (Electra Elite 192), or slot S2 of the B48-U10 KSU (Electra Elite 48) when
the MIF-Modem Unit is installed.
RELATED
FEATURES LIST
Refer to PC Programming Section of the Programming Manual.
Feature
Number
Feature Name
P-2
PC Programming
To Next Page
Loading...