Features and Specifications Manual K - 1
Key Function/Multifunction
Registration
K-1
FEATURE
DESCRIPTION
The system can be registered as either a Key Function (KF) or a Multifunction
(MF) telephone system. This feature is set by a switch on the CPUB( )-U10
ETU for the Electra Elite 192 system or on the MBD-U10 Unit in the B48-U10
KSU for the Electra Elite 48 system during installation.
SYSTEM
AVAILABILITY
Terminal Type:
Not applicable
Required Components:
CPUB( )-U10 ETU (Electra Elite 192)
B48-U10 KSU (Electra Elite 48)
OPERATING
PROCEDURES
SERVICE
CONDITIONS
General:
When the system is set as KF, CO/PBX lines must appear on Multiline
Terminals. Outside calls cannot be made by dialing a Trunk Access
Code from internal dial tone except when specified trunk seizure is used.
When a system is set as KF, the following CO/PBX calls are prohibited:
• Route Advance key
• Trunk Group key
• Hot Line/Prime Line with Automatic Trunk Selection
• Trunk Group Access Call, Route Advance Access Call
• Least Cost Routing (LCR)
• Speed Dial with Automatic Trunk Selection
• Last Number Redial with Automatic Trunk Selection
None
To Next Page
Loading...