Features and Specifications Manual N - 1
Nesting Dial
N-1
FEATURE
DESCRIPTION
Multiline Terminal users may store up to four System or Station Speed Dial
numbers in one Station Speed Dial buffer. The user can press the Redial key
and dial a single Station Speed Dial buffer number to consecutively dial all
four buffers.
System Software S4000 or higher permits input stored characters to be
entered on the dial pad, but does not allow the Character Code Table to
be used.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
1. Press
T
.
2. Press
Q
.
3. Dial the Speed Dial buffer number to be programmed
(
KK
~
II
or
KKK
~
III
).
4. Dial the Trunk or Trunk Group Access Code (maximum 4 digits).
5. Press
O
.
6. Dial the Speed Dial buffer number to be nested (
KK
~
II
or
KKK
~
III
).
7. Repeat steps 5 and 6 up to three times if required.
8. Press
U
, and enter name using the Character Code Table.
- OR -
9. Use the dial pad to enter the name.
Refer to S-11 Speed Dial Stored Characters.
To program Nesting Dial for a Speed Dial buffer:
To Next Page
Loading...