Features and Specifications Manual D - 9
Dialed Number Indication
Service (DNIS)
D-4
FEATURE
DESCRIPTION
DNIS allows a name to be assigned to inbound DID digits. This feature allows
more efficient call handling.
System Software S5000 or higher is required.
SYSTEM
AVAILABILITY
Terminal Type:
All Display Multiline Terminals
Required Components:
DID(4)-U10, TLI(2)-U10, PRT(1)-U10/20, or DTI-U10/20
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-20 (DID Digit Length Selection) to set 2, 3
(default), or 4 incoming digits.
Use Memory Block 1-1-21 (DID Digit Conversion Assignment) to enable
(YS) digit conversion. Default is NO.
Use Memory Block 1-1-22 (DID Digit Conversion Table) to assign DNIS/
DID digits to be routed. A name can be assigned to the digits using
System Software S5000 or higher.
Use Memory Block 1-1-78 (Caller ID Display Assignment for System
Mode) to assign 15 telephones to display the name for DNIS digits.
Default is not assigned.
Use Memory Block 1-8-08 [Class of Service (Station) Feature Selection
2] Page 4 LK4 to select Allow (LED On) to display Number or Deny
(default: LED Off) to display Name.
Use Memory Block 1-8-08 [Class of Service (Station) Feature Selection
2] Page 4 LK3 to Allow (LED On) or Deny (default: LED off) Caller ID.
None
To Next Page
Loading...