Features and Specifications Manual P - 23
Programming from
Multiline Terminal
P-10
FEATURE
DESCRIPTION
System Programming can be performed from designated Display Multiline
Terminals in the first two ESI(8)-U10 ETU ports. Some programming changes
become effective immediately. Other programming changes become effective
after applicable busy telephones and circuits become idle.
SYSTEM
AVAILABILITY
Terminal Type:
Display Multiline Terminals
Required Components:
ESI(8)-U10 ETU
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify the
ESI(8)-U10 ETU.
Restrictions:
PC Programming and programming from a Multiline Terminal cannot be
performed at the same time.
General:
The first two Multiline Terminal ports are programming positions (default:
Stations 100 and 101).
Both stations can go off-line at the same time to program the system.
Refer to the Electra Elite 48/192 Programming Manual for
additional information.
To Next Page
Loading...