Features and Specifications Manual R- 1
Recall Key
R-1
FEATURE
DESCRIPTION
The Recall Key either generates a hookflash to access features provided by
the outside exchange or abandons a call while retaining the CO/PBX line for
another call. Each Multiline Terminal has a Recall key. The function of this key
is programmed.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
1. Press
S
.
2. Receive new CO dial tone; line is not released.
1. Press
S
.
2. Receive PBX/Centrex second dial tone.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-02 (Hookflash Time Selection) to assign the
hookflash time (default: 600 milliseconds) system-wide.
A hookflash can be programmed as any digit in a Speed Dial buffer.
Use Memory Block 1-3-02 (SLT Hookflash Signal Selection) to allow
Single Line Telephones to generate a hookflash (FLASH) on a CO/PBX
line system-wide. Default is HOLD.
To use this feature with an outside CO call in progress:
To use this feature with a PBX/Centrex call in progress:
To Next Page
Loading...