Features and Specifications Manual T - 15
Trunk-to-Trunk Transfer
T-7
FEATURE
DESCRIPTION
Trunk-to-Trunk Transfer allows any station user to establish Trunk-to-Trunk
Transfers between two CO/PBX (when disconnect signal is provided), DID,
and/or E&M Tie line calls.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
1. Press
N
, and wait for internal dial tone.
2. Dial the Trunk Access Code (either CO/PBX line, DID, or E&M Tie
line) for desired trunk or press outside line key appearance.
3. Press
T
.
4. Press
N
to establish a Trunk-to-Trunk connection.
5. Hang up.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-4-00 (Tandem Transfer Automatic Disconnect Time
Selection) to specify the maximum time (default: 060 sec.) before the
system automatically disconnects a Trunk-to-Trunk Transfer.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
Selection 1] Page 1 LK7 to Allow (default: LED On) or Deny (LED Off)
Attendant Automatic Trunk-to-Trunk Transfer Set/Reset for each Class
of Service.
Use Memory Block 1-8-08 [Class of Service (Station) Feature Selection
2] Page 3 LK5 to Allow (LED On) or Deny (default: LED Off) Station
Trunk-to-Trunk Transfer for each Class of Service.
Using Multiline Terminal with an outside call in progress:
To Next Page
Loading...