Features and Specifications Manual D - 7
Delayed Ringing
D-3
FEATURE
DESCRIPTION
Delayed Ringing allows programmed secondary answering positions to ring
on incoming calls after a programmed time. This feature applies to CO/PBX
lines, Secondary Incoming Extensions, and Call Arrival Keys.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
1. Receive delayed incoming ring.
2. Answer the call normally.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-77 [Delayed Ringing Time Assignment (CO)] to
set the time (default: 15 seconds) between the detection of an incoming
outside line call and the start of Delayed Ringing.
Use Memory Block 1-2-26 [Delayed Ringing Time Assignment (ICM)] to
set the time (default: 10 seconds) between the detection of an incoming
internal call and the start of Delayed Ringing.
Use Memory Block 2-01 (Trunk to Tenant Assignment) to resolve Tenant
Ringing conflicts by Trunk to Tenant Assignment. The lower number
assigned tenant is used as the ringing control.
Restrictions:
When a CO line is assigned DIT/ANA to a station that also has Delay
Ringing assigned, the DIT/ANA does not occur until the Delay Ringing
time expires.
To process an incoming call:
To Next Page
Loading...