Features and Specifications Manual T - 5
Tenant Service
T-3
FEATURE
DESCRIPTION
Tenant Service subdivides the system into a maximum of 48 Tenants that have
outside line access.
SYSTEM
AVAILABILITY
Terminal Type:
Not applicable
Required Components:
None
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-22 (DID Digit Conversion Table) to direct
incoming DID calls to a specific Tenant (System Software S4000 or
higher is required).
Use Memory Block 1-4-12 (Automated Attendant Message to Tenant
Assignment) to assign Automated Attendant messages to tenants.
Use Memory Block 2-01 (Trunk to Tenant Assignment) to assign CO/
PBX lines to tenants 00~47 (default: All CO/PBX lines and stations are
assigned to Tenant 00).
Use Memory Block 2-05 (Line Key Selection) to select TNAT (Tenant-
Wide Mode) or TEL (Telephone Mode default) line key assignment.
Default is TEL.
Use Memory Block 2-06 (Line Key Selection for Tenant Mode) to assign
functions to each CO/PBX line key on each telephone in a tenant.
Default is CO.
Use Memory Block 2-07 (System Speed Dial Display Assignment) to
specify whether or not confirmation of the speed dial numbers and
messages is allowed for tenants. Default is Yes (LEDs On).
None
To Next Page
Loading...