Features and Specifications Manual P - 5
PC Programming
P-2
FEATURE
DESCRIPTION
The MIFM-U10 ETU and System Administration Terminal (SAT) software allow
the system to be programmed from a personal computer (PC). System Data is
transferred to/from a diskette for backup of system data. SAT PC
programming software also allows the user to print station designation strips
to shorten installation time. End users can use end-user SAT PC programming
software to program several features for their Multiline Terminals such as: Line
Key Assignment, Telephone Names, Zone Paging Groups, or various
programmed times.
SYSTEM
AVAILABILITY
Terminal Type:
Not applicable
Required Components:
MIFM-U10 ETU
Pentium PC with Windows 95 or higher to run SAT PC programming
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-8-17 (PC Programming Password Assignment) to
set a system password that must be entered when using PC
Programming.
Use Memory Block 1-8-18 (Site name Assignment) to enter a system
name (8 digits maximum) to use to program the system.
Use Memory Block 1-8-35 (COM Port Baud Rate Setting Assignment) to
individually define the baud rate for COM ports.
Use Memory Block 1-8-36 (COM Port Parity/Stop Bit setting
Assignment) to individually define the Parity and Stop Bit for COM ports.
Refer to the Electra Elite Programming Manual for PC
programming instructions.
To Next Page
Loading...