Features and Specifications Manual A - 67
Automatic Number Indication
(ANI) on T1
A-22
FEATURE
DESCRIPTION
T1 ANI displays the calling party telephone number on the LCD of the Multiline
Terminal for incoming trunk calls. ANI information follows the call to where it is
transferred.
Historically ANI has been a feature of long-distance carriers typically provided
on T1 circuits. The Electra Elite system supports ANI on T1-FGD (Feature
Group D) trunks. ANI trunks are incoming only. This feature is functionally the
same as Caller ID.
System Software S3000 or higher supports incoming only.
System Software S4500 or higher supports outgoing on Feature Group D
trunks.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals with display
Required Components:
DTI-U10/20 ETU
MIFM-U10 ETU with KMM(1.0)U installed when ANI Scrolling and/or Call
Return are used.
OPERATING
PROCEDURES
Press the Scroll key to display the last incoming ANI. Repeatedly press the
Scroll key to display a maximum of 10 ANI numbers.
Note: The Scroll key is programmed using Memory Block 4-12 (Line Key Selection for
Telephone Mode). Refer to the Electra Elite 48/192 Programming Manual for
instructions.
To display a stored ANI:
To Next Page
Loading...