Features and Specifications Manual D - 13
Digit Insertion
D-6
FEATURE
DESCRIPTION
Digit Insertion provides user friendly operation when the system is installed
behind a PBX or Centrex Central Office. When a system user originates an
outgoing call, the system automatically inserts the PBX/Centrex Trunk Access
Code. This feature saves the user from dialing an additional Access Code.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
1. Lift the handset, and wait for internal dial tone.
2. Dial the Trunk Access Code, then dial the desired telephone number.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Blocks 1-1-46~48 [Access code (1-, 2-, or 3-Digit)
Assignment] to assign a 1, 2, or 3-digit Trunk Access Code.
Use Memory Block 1-1-50 (CO/PBX Outgoing Digit Add Assignment) to
specify up to 10 additional digits when a trunk in the trunk group or route
advance block assigned in Memory Block 1-1-49 (Networking Trunk
Group/Route Advance Assignment) is seized, and a number is dialed.
General:
The Trunk Access Code of the Electra Elite should be the same number
as the Trunk Access Code of the PBX/Centrex.
An outside call by Digit Insertion feature complies with Code Restriction.
Digit Insertion can be assigned per Trunk group.
Digit Insertion can be assigned to a maximum of 16 Trunk groups.
To make a call using Digit Insertion:
To Next Page
Loading...