Features and Specifications Manual F - 7
Flexible Line Assignment
F-3
FEATURE
DESCRIPTION
Each Multiline Terminal has complete flexibility of line key assignments to
meet individual needs. Functions can be programmed on Flexible Line Keys,
including DSS numbers and a variety of Feature Access Codes to simplify the
use of these functions. Outside line appearances and Secondary Incoming
Extensions can also be assigned to Flexible Line keys.
SYSTEM
AVAILABILITY
Terminal Type:
All Multiline Terminals
Required Components:
None
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 2-05 (Line Key Selection) to select TNAT (Tenant
Mode) or TEL (Telephone Mode). Default is TEL.
Use Memory Block 2-06 (Line Key Selection for Tenant Mode) to assign
functions to each telephone in Tenant Mode. Default is CO.
Use Memory Block 4-12 (Line Key Selection for Telephone Mode), to
assign functions to each telephone in Telephone Mode. Default is CO.
Use Memory Block 4-50 (Multiline Terminal Type Selection) to assign a
DTU terminal with 16 (default) or 24 line keys.
General:
Each Flexible Line key can be assigned one of the following options:
• NON (not assigned)
• CO Outside Lines (01~64)
• Trunk Groups (01~32)
None
To Next Page
Loading...