T - 16 Trunk-to-Trunk Transfer
Issue 6 Electra Elite
Use Memory Block 3-04 (Trunk-to-Trunk Transfer Yes/No Selection)
to specify per trunk whether (YES) or not (default: NO) to allow this
feature.
Restrictions:
A Single Line Telephone cannot be used for Trunk-to-Trunk Transfer.
General:
All lines used for Trunk-to-Trunk Transfers must provide remote
disconnect supervision.
A conference circuit is not required for a Trunk-to-Trunk Transfer.
A Station user cannot reenter a Trunk-to-Trunk Transfer after the
connection is established.
After a Trunk-to-Trunk Transfer is established, both trunks are
released when a disconnect signal is received by either trunk or
when the Automatic Disconnect Time runs out.
When a Trunk-to-Trunk Transfer is established using Call
Appearance keys, the LED stays on until the trunks are released.
To Next Page
Loading...