E - 26 Emergency 911 - Cut Through
Issue 6 Electra Elite
Use Memory Block 1-1-24 (PBX/CTX Access Code Assignment 1)
and Memory Block 1-1-25 (PBX/CTX Access Code Assistant 2) to
assign access codes when CTX/PBX trunks are assigned.
Use Memory Block 3-33 (Disconnect Recognition Time Selection) to
assign the time the dropped line remains idle before the line is seized
for 911 calls.
Restrictions
The station user cannot press a busy Direct CO Line and dial
9+911or 911.
When 911 is not dialed continuously (e.g. dial 9+1+RECALL+1), the
911 call is not placed.
When Memory Block 3-92 is assigned as NIL and Memory Block 3-
69, is set to YES, Emergency 911 - Cut Through feature is not
supported.
When all trunks in Memory Block 3-69 are set to No, the Emergency
911 - Cut Through feature is not supported.
CAMA trunk and Emergency 911 - Cut Through cannot be used at
the same time.
When the CO line status is as follows, even when Yes is specified by
Memory Block 3-69, the call is not dropped and/or disconnected.
• Receiving Normal Incoming call
• Receiving DIT call
• Incoming Automated Attendant
• Originating 911 call
• Receiving ACD Incoming call
Emergency 911 - Cut Through does not override the following
features:
• Digit Restriction set in Memory Block 4-19 (Trunk Outgoing
Restriction)
• Automatic Trunk-to-Trunk Transfer (out going trunk only)
• Attendant Station Outgoing Lockout
• FAX branch Connection
When a station dials 911 while a line is being used by the Fax Branch
Connection, this line is not dropped.
To Next Page
Loading...