C - 54 Call Park - System
Issue 6 Electra Elite
1. Go off-hook, and wait for internal dial tone.
2. Dial the Call Park Retrieve Access Code
DL
(set as
default).
3. Dial the Call Park location number (
K
~
I
) of the call to be
retrieved.
4. Talk with party.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] to assign Access Code (4# for Call Park System Answer
or 4* for Call park System Transfer).
Use Memory Block 1-2-23 (System Call Park Recall Time Selection),
to specify the time (default: 1 minute) before a parked call recalls
back to a station.
General:
Any call left in Call Park more than the programmed time recalls to
the station where the call was originally parked. The Call Park
location becomes idle after the recall, and the trunk line key switches
to Non-Exclusive Hold.
When attempting to set Call Park to a busy Call Park location, and a
busy tone is heard, Step Call can be used to access an idle location
to park the call.
When a station other than the station originally used to park the call
retrieves the call, the SMDR records a transfer to the station where
the call is retrieved.
When a Call Park is in recall mode, the call cannot be picked up
using the Call Park retrieval Access Code.
Call Park is set and retrieved from internal dial tone.
Outside calls and internal calls can be parked from any station.
Conference calls cannot be parked.
When attempting to set Call Park and all Call Park locations are busy,
a busy tone is heard and ALL PARK BUSY is displayed on Display
Multiline Terminals.
To retrieve a parked call at either a Multiline Terminal or a Single
Line Telephone:
To Next Page
Loading...