Electra Elite Issue 6
Features and Specifications Manual 1- 3
Feature Access Keys
Depending on the type, a Multiline Terminal can have 2, 8, 16, or 24
Line keys. For Series 4500 and below, a maximum of 10 line keys
can be assigned as Feature Access to allow direct access to
features. Using System Software S5000 or higher, a maximum
of 16 keys can be assigned for Feature Access. These highly-
flexible keys can be used for station DSS/BLF and Speed Dial also.
Single On/Off Keys
Line keys may also be assigned as Single On/Off keys in System
Programming to toggle a feature on/off. This assignment has no
impact on the Feature Access keys, but the assigned features are
very specific. Call Forward All Call, Call Forward Busy/No Answer,
Scrolling (CID), headset, and DND are examples of features
available for Single On/Off keys.
One-Touch Keys
One-Touch keys can perform the same function as Feature Access
keys. A Multiline Terminal has a fixed number of these keys. No
system assignment is necessary, and the number of keys ranges
from none to 20 depending on the terminal type.
Figure 1-1 Key Assignment Example
16 One-Touch Keys
Feature Access Keys (16
maximum) or Single
On/Off Keys
To Next Page
Loading...