Electra Elite Issue 6
Features and Specifications Manual C - 63
Use Memory Block 3-42 (DIT Assignment) to assign Day Mode direct
trunk termination to a station.
Use Memory Block 3-43 (ANA Assignment) to assign Night Mode
trunk termination to a station.
Use Memory Block 1-2-22 (Call Forward - No Answer Time
Selection) to specify the Call Forward - Busy/No Answer time.
Restrictions:
Each system must have a Voice Mail Quick Transfer Master Hunt
number assigned, but Voice Mail Call Back Indication is not
supported in the system without Voice Mail.
The Closed Numbering Network is required to support Centralized
Voice Mail. Refer to
<<BlueText>$paranum><<BlueText>$paranum> U-3 Uniform
Numbering Network in this Manual for details.
All systems in the Closed Numbering Network using the same Voice
Mail must assign the same Access codes for Memory Block
1-1-46~48, Functions 502 and 503, to set or cancel message
indication.
Systems without Voice Mail can access DIT/ANA trunks to the
Automated Attendant of the Centralized Voice Mail using a CAR key
that has Call Forward–Off-Premise to the Voice Mail pilot.
Soft key indication is not supported in remote systems. Refer to
Features Supported by Digital Voice Mail for a detailed list of
supported features.
Analog voice cannot be used to support Centralized Voice Mail.
General:
The Voice Mail system controls the Voice Mail Message Indication for
systems without Voice Mail using Analog or Digital Tie Lines.
Centralized Voice Mail does not require upgrade of the Digital Voice
Mail System.
When using multiple systems in a network, Internal/External Pad
Selection may need adjustment to compensate for volume loss.
Using Multiple Call forwarding to transfer calls between systems is
not recommended.
To Next Page
Loading...