D - 38 Direct Paging Access
Issue 6 Electra Elite
Default Memory Block 1-1-46 [Access Code (1-Digit) Assignment]
Dial Numbers are shown below:
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the ECR-U10 ETU.
Internal Zones A, B, and C are not active until zone assignments are
made.
Restrictions:
All Internal/External Page Access cannot be programmed to a key on
the Attendant Add-On Console.
General:
When a Direct Paging Access key for All Internal Zone or Internal
Zone Page on the Attendant Add-On Console is pressed, a paging
announcement is made over the speakers of all idle Multiline
Terminals programmed in a zone.
Paging access through external speakers is available when a system
has external speakers. An optional ECR-U10 ETU is required.
Single Line Telephone users can access Internal and External
Paging and Meet-Me by using an Access Code, but cannot receive a
paging announcement.
Feature Access and One-Touch keys on Multiline Terminals can be
assigned for paging allowed in System Programming, including the
features listed previously and All Internal Call Paging, Internal/
External Paging, and specific Tenant Internal Paging.
RELATED FEATURES
LIST
Dial
No.
Dial
No.
1. All Internal Zone 51 5. All External Zone 55
2. Internal Zone A 52 6. External Zone A 56
3. Internal Zone B 53 7. External Zone B 57
4. Internal Zone C 54 8. External Zone C 58
Feature
Number
Feature Name
A-8 Answer Hold
E-11 External Zone Paging (Meet-Me)
I-5 Internal Zone Paging (Meet-Me)
To Next Page
Loading...