D - 52 Door/Monitor Telephone
Issue 6 Electra Elite
1. When the Doorphone Ringing is ringing at another station, dial
the DP1, DP2, DP3, or DP4 Access Code for the specific
doorphone that is ringing.
2. The Door Lock Release Relay can be controlled while you talk
with the doorphone user.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-7-00 (Doorphone Assignment) to enable (LED
ON/default: LED Off) doorphones.
Use Memory Block 1-7-01 (Doorphone Display Time Selection) to
define the time (default: 10s) before a doorphone call times out.
Use Memory Block 1-7-04 (Doorphone Ring Pattern Selection) to
define the doorphone ringing pattern (default: ON).
Use Memory Block 1-7-05 (Doorphone Ringing Frequency
Selection) to define the doorphone ringing frequency (default: C).
Use Memory Block 4-03 [Doorphone Chime Assignment (Day
Mode)] or 4-04 [Doorphone Chime Assignment (Night Mode)] to
assign Day Mode or Night Mode doorphone chime.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the DPH(4)-U10 ETU.
Restrictions:
Doorphone Ringing cannot be assigned to Single Line Telephones,
including those supported by analog port adapters.
General:
Doorphones 1 and 3 share a speech path and doorphones 2 and 4
share a speech path. When a doorphone is busy, the speech path is
busy. Ringing indication works, but the other doorphone cannot be
answered until the speech path is idle.
RELATED FEATURES
LIST
To answer a Doorphone that is ringing at another Multiline
Terminal:
Feature
Number
Feature Name
D-16 Door Lock Release Relays
To Next Page
Loading...