Electra Elite Issue 6
Features and Specifications Manual D - 59
1. Pick up the handset, and press talk.
2. Listen for dial tone.
3. Press redial to dial the last number called.
1. Remove the handset from the Base, and press memory. The
talk/battery low LED flashes.
2. Enter the telephone number (up to 20 digits) to be stored.
3. Press memory, and enter the memory location (0~9) to be used
for storage.
4. Listen for a long beep, and the talk/battery low LED goes off to
indicate the number is stored.
Note:When any key other than 0~9 is selected, the handset beeps rapidly
to indicate that a number was not stored.
5. Log the number entered.
1. After entering the number to be stored in memory, press pause
to enter a pause in the number sequence.
Note:When pause is to be entered it counts as a digit, and the number can
have only 19 digits.
2. Complete steps 3~5 of the memory store procedure.
1. Remove the handset from the Base, and press memory.
2. Press tone.
Note:When tone is pressed it counts as a digit, and the number can have
only 19 digits.
3. Enter telephone number (up to 19 digits) to be stored.
To redial:
To store a pulse-dialed number in memory:
To enter a pause in memory dialing:
To store a tone-dialed number in memory:
To Next Page
Loading...