D - 80 D
term
® Cordless II Terminal
Issue 6 Electra Elite
1. Verify that the base unit is in Desk mode.
2. Remove battery.
3. Press and hold
J
and
L
on the handset.
4. Install the battery while holding these keys.
5. After the handset beeps one time, release the keys.
6. The handset is in Setup mode.
7. Press HOLD to display the current mode (Digital/Redial).
8. Press F2 and then HOLD.
9. The handset displays Digital (F8), and changes the REDIAL key
program to Desk/Cordless Softkey Switching mode.
10. Press TALK to restore standby mode.
11. Press REDIAL to test this feature.
12. The base unit automatically changes from Desk to Cordless.
Note: This is a one time operation, but one of the F1~F4 keys can be programmed for
the redial function.
13. To restore the normal redial function, enter setup mode, and
press F3 and HOLD to display Digital (Redial).
14. Press TALK to restore standby mode.
SERVICE
CONDITIONS
General:
When a message is received the
u
icon is displayed.
When the RING OFF/ON switch on the right side is down the
OFF
icon is displayed
.
When the battery is low, the icon is displayed.
When there is no transmission between the base unit and the
handset for about five minutes, there are no LCD or LED indications
on the cordless terminal handset. Ringing off-hook or pressing keys
resumes LCD and LED indications.
The ring pattern for the cordless terminal can be selected by System
Programming and Multiline Terminals.
LOW
To Next Page
Loading...