D - 92 D
term
® IP Gateway System
Issue 6 Electra Elite
SOFTWARE
SUPPORT
TCP/IP protocol for support of IP traffic and management
RVPoIP uses UDP/IP protocol for voice transmission
Serial RVP uses HDLC encapsulation for voice transmission
Management and utilities: Telnet, inband RVP, RS-232 console
interface (Gateway and Branch), SNMP, and HTML
Software upgradable, using FTP, between the Gateway and the
branch, RS-232 serial port to PC, or inband connection
SYSTEM
AVAILABILITY
Terminal Type:
DTP/DTU Multiline Terminals
DTP-32DE-1 for home environment
REQUIRED
COMPONENTS
Components include the following:
Electra Elite KTS with 1 ESI port for each Branch port and IP Adapter
1 Gateway unit
1 Branch unit and/or IP Adapters with total ports not exceeding the
number of ports supported by the Gateway unit
1 Power Cord
1 RS-530 cable
2 RJ-21 50 pin cables to connect Gateway to DTS and Branch to
punch block – connectors required include a female connector to
attach to D
term
IP, and a male connector to attach to the KTS
Punch blocks that can crossconnect the D
term
IP Gateway to the KTS
and D
term
telephones to the branch locations
Installation hardware for Gateway and Branch units
1 System Administrator’s Guide
1 Quick Installation Guide
1 Application Guide
PC for configuration
T1, Fractional T1, ISDN, Frame Relay or ATM circuit that can connect
the Branch unit to the Gateway location
To Next Page
Loading...