Electra Elite Issue 6
Features and Specifications Manual E - 31
A system that provides service to a different address using OPX
circuits must provide a specific CESID for that station. The CESID is
provided by the TELCO when the OPX circuit is provided. The KTS
administrator must file a callback number along with this CESID to
the E911 system that then places this information in the E911 system
database.
When the E911 trunk is busy, the system allows the call to be routed
over another trunk. This is software selectable. No Alternate Routing
is the default (with a warning not to change it to Allow) because of the
concern that under catastrophic conditions a single location could
overload the emergency system with multiple 911 calls.
When a call is originated using Enhanced 911, the CAMA or ISDN
PRI trunk is seized even when a CESID code is not registered.
The E911 trunk should not be assigned to a line key, trunk group,
route advance block, Specified Tenant on CO/PBX/Centrex Line
Seizure (1- or 2-digit), or Outgoing (CO only) Access in Same
Tenant.
Enhanced 911 is available only when a CAMA or ISDN PRI trunk is
connected and assigned to the system.
The Facility Interface Code (FIC) for a dedicated CAMA or ISDN PRI
trunk is 02RV-O. This code is provided when service is ordered to
indicate the trunk type.
The following features cannot restrict the station ability to dial 911:
• Account Code - Forced/Verified/Unverified
• Station Outgoing Lockout
•LCR
• Caller ID Blocking
To Next Page
Loading...