E - 38 External Zone Paging (Meet-Me)
Issue 6 Electra Elite
1. Lift the handset.
2. Dial the desired Access Code
EE
~
EI
(as set in
default) for the required zone.
1. Lift the handset.
2. Dial the Meet-Me Access Code (
EJ
, when the page is an
Internal/External Page, or
EL
, when the page is only an
External Page, as set in default).
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-7-06 (External Paging Timeout Selection) to
specify the External timeout time (default: 5 minutes) before a page
automatically disconnects.
Use Memory Block 1-7-03 (External Paging Alert Tone Selection) to
specify whether (YS/NO) an alert tone is sent to external speakers at
the beginning of the external page.
Use Memory Block 1-7-02 (External Speaker Connection Selection)
to specify that external speakers must be connected to the system
when they are to be used. Up to three external speakers can be
connected. Default is all three connected.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the ECR-U10 ETU.
Internal and External Zone Paging time outs can be assigned
individually. During an All Internal/External Zone Page, the external
timeout time is used.
Restrictions:
When an External Zone Page is in progress (either Zone A, B, C, or
All Zone), no other station can activate External Zone Paging until all
zones become idle again.
A single paging zone that provides pre-alert tone only is built in on
the Electra Elite 48 system. Chime tone is not supported.
To originate using a Single Line Telephones:
To answer using a Single Line Telephones:
To Next Page
Loading...