H - 10 Hold With Recall (Exclusive and Non-Exclusive)
Issue 6 Electra Elite
1. Momentarily press the hookswitch; the call is placed on Exclusive
Hold. When the handset is returned to the cradle, the call recalls
immediately.
2. To retrieve a held call, momentarily press the hookswitch; the
held call is connected.
- OR -
To retrieve a held call, return the handset to the cradle.
3. When recall begins, lift the handset and the call is connected.
SERVICE
CONDITIONS
Multiline Terminal
Non-Exclusive Hold
After Non-Exclusive Hold is set, the user can originate or answer
other calls.
Any station with the same outside line or programmed Call
Appearance key can pick up the held call.
A CO/PBX call on Non-Exclusive Hold can be picked up by dialing an
Access Code (Specified Line Seizure) when assigned in System
Programming.
Use Memory Block 1-1-03 [Hold Recall Time Selection (Non-
Exclusive Hold)] to specify the time (default: 25 seconds) that the call
is held or parked before it recalls to the station where the call was
placed on Hold.
The station where the Hold originated receives an I-Hold indication
(flashing green LED). The LED associated with the held line key
flashes red on all other Multiline Terminals.
Exclusive Hold
After Exclusive Hold is set, the user can originate or answer other
calls.
When assigned, a call is held on a CO line key appearance. When
not assigned, the call is exclusively held on a Call Appearance key.
Using a Single Line Telephone with a call in progress:
To Next Page
Loading...