I - 8 Internal Voice/Tone Signaling
Issue 6 Electra Elite
1. Lift the handset, and wait for internal dial tone.
2. Dial the station number. (Called party station rings.)
3. Talk with party after the call is answered.
- OR -
Dial
A
(set as default).
4. Voice announce the call.
5. Called party can reply handsfree.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-2-01 (Intercom Call Voice/Tone Signal
Selection) to select VOICE (default) or TONE to be used first for an
intercom call.
Use Memory Block 1-6-03 (DSS Call Voice/Tone Signal Selection) to
select VOICE (default) or TONE to be used when calling an
extension from the Attendant Add-On Console.
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] to Allow (default: LED On) or Deny (LED Off) Voice/Tone
Override Originate (Page 1 LK8) or Voice/Tone Override Receive
(Page 3 LK3).
Restrictions:
Single Line Telephone users can voice announce to Multiline
Terminal users but cannot receive voice announcements.
General:
Voice or Tone can be selected as often as needed by dialing 1
(default) during a call.
When the station is receiving a handsfree call, the MIC must be
activated for reply.
A Single Line Telephone user can switch from voice to tone or from
tone to voice by dialing 1 (default) during an internal call to a Multiline
Terminal.
When a voice announcement is received at a Multiline Terminal,
other audible signals cannot be received.
When programmed for Tone/Voice:
To Next Page
Loading...