L - 4 Last Number Redial
Issue 6 Electra Elite
SERVICE
CONDITIONS
Data Assignment:
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] to change Last Number Redial Access Code (default:
,
).
Restrictions:
Internal calls do not apply to this feature.
General:
Last Number Redial memory is protected by battery backup.
Last Number Redial stores up to 24 digits (plus the Trunk Access
Code).
The Access Code
,
is fixed in system software for use with the
Redial key.
This feature can be assigned to a Feature Access or One-Touch key.
To store the last Dial Access number dialed in a Station Speed Dial
buffer, press the Feature key and Redial key, dial the Speed Dial
buffer number, and press Redial key, then the Feature key.
To display the Last Number Redial memory buffer, press the Conf
key, Redial key, and then
,
.
A Private Line must be accessed by Direct CO access for Redial to
operate.
Manually dialed numbers, Speed Dial numbers, Save/Store and
Repeat numbers, One-Touch dial numbers, or combinations can be
redialed using the Last Number Redial feature when the last number
dialed is less than 24 digits.
A Trunk Access Code is automatically inserted when the last call was
made by manually selecting an outside line.
To Next Page
Loading...