M - 14 Multiple Trunk Groups
Issue 6 Electra Elite
Default Trunk Access Codes include the following:
• Dial 9 Trunk Group 1
• Dial 8 Trunk Group 2
• Dial 70 Trunk Group 3
• Dial 71 Trunk Group 4
• Dial 72 Trunk Group 5
• Dial 73 Trunk Group 6
• Dial 74 Trunk Group 7
• Dial 75 Trunk Group 8
Use Memory Block 3-03 (Trunk-to-Trunk Group Assignment) to
assign a Trunk Group number (01~32) to each CO/PBX line.
Restrictions:
A trunk can be assigned to only one Trunk group.
General:
Dial Access is provided only on Multifunction registered systems.
At default, CO/PBX lines 01~ 08 are assigned in Trunk Group 1, all
Tie lines are assigned in Trunk group 2, and no additional CO/PBX
lines or DID lines are assigned to a Trunk group.
The system provides for 32 Trunk groups.
Trunks can be assigned to any or all Tenant groups.
Various features such as Code Restriction (outgoing), LCR, and
Route Advance Block are based on Trunk groups.
Trunk groups can be assigned to a Flexible Line key as a Pooled Line
(outgoing).
To Next Page
Loading...