P - 14 Prime Line Assignment
Issue 6 Electra Elite
1. Lift the handset.
2. Press the hookswitch.
3. Dial the desired Feature Access Code or station number.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 4-23 (Prime Line/Hot Line Assignment) to assign
Prime Line to a Trunk, Trunk Group, or Route Advance Block.
Prime Line is assigned per station.
Restrictions:
When Prime Line is busy or on Hold, a busy tone is received when
user goes off-hook. Another line must be seized manually.
General:
Ringing Line Preference takes priority over Prime Line when both
features are assigned.
Internal Dial Tone Access Codes can be stored on a Feature Access
or One-Touch key.
An internal line can be seized by pressing the ICM key (when
assigned) before going off-hook.
Prime Line can be assigned to a Single Line Telephone.
When a Single Line Telephone user provides a hookflash, the outside
line is put on hold and internal dial tone is heard. To return to the
outside line, provide another hookflash.
The Service Conditions for Multiline Terminals when the Feature key
and Access Code 6
,
are used to access intercom dial tone include:
• The seized outside line is disconnected and internal dial tone is
provided.
• During an internal call or when receiving call waiting tone, busy
tone, or reorder tone, press the Feature key and dial 6
,
again
to provide new internal dial tone.
• When an incoming internal or ring transfer call is being received
while off-hook, and an outside dial tone is received, press the
Feature key and dial 6
,
to answer the call.
To access an internal dial tone for Feature Access or an internal
call at a Single Line Telephone:
To Next Page
Loading...