S - 58 Station Relocation
Issue 6 Electra Elite
SERVICE CONDITIONS Data Assignment:
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] Function Number 148 to assign an Access Code for
Station Relocation.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
Selection 1] Page 3 LK 1 to Allow (default: LED On) or Deny (LED
Off) any Attendant to set the Terminal Exchange Mode.
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] Page 5 LK 3 to Allow (default: LED On) or Deny (LED
Off) any user to set Station Relocation.
Restrictions:
This feature cannot be used with the following combinations:
An error tone is received and ERROR is displayed in the LCD under
the following conditions:
• A station number that causes a prohibited combination is
entered.
• A station number that does not exist is entered.
• The station number of the terminal being used to perform
Station Relocation is entered.
• A Pilot Number or CAR number is entered.
• The wrong password is entered.
• A station number of the terminal to be exchanged is entered
and that station is not idle.
• Station Relocation Mode is not set.
This feature cannot be used to relocate DSS Consoles because
consoles are not assigned station numbers. When Station
Relocation is performed for a station that has an associated DSS
Console, the station is relocated but not the DSS Console.
Electra Professional............................Single Line Telephone
Electra Professional............................Single Line Telephone Adapter
Electra Elite.........................................Single Line Telephone
Electra Elite.........................................Single Line Telephone Adapter
Single Line Telephone.........................Single Line Telephone Adapter
To Next Page
Loading...