S - 62 Station Transfer
Issue 6 Electra Elite
1. Provide hookflash. The call is put on Exclusive Hold. Receive
internal dial tone.
2. Dial the station number of the station where call is to be
transferred.
3. Hang up.
- OR -
When the party answers, announce the transfer.
4. Restore the handset (transfer is completed).
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-11 (System Transfer/Camp-On Selection) to
allow (default: YS) or deny (NO) Ring Transfer.
Use Memory Block 1-1-12 (Station Transfer/Camp-On Recall Time
Selection) to specify a Station Transfer time (default: 45 seconds)
before recall for a station without an Attendant Add-On Console.
Use Memory Block 1-1-13 (CO Transfer Ring Pattern Selection) to
select the ring pattern (default: C) for CO transfer.
Use Memory Block 1-1-14 (CO Transfer Ring Tone Selection) to
select the Ring Tone (default: A) for CO transfer.
Use Memory Block 1-1-64 (Attendant Add-On Console Transfer/
Camp-On Recall Time Selection) to specify a Station Transfer time
(default: 1 minute) before recall for a station with an assigned
Attendant Add-On Console.
General:
After transferring an answered call, the Multiline Terminal user can
enter a conference by pressing the Conference key on the Multiline
Terminal even after the Transfer key is pressed.
After transferring an answered call, the Single Line Telephone user
can enter a conference by providing a second hookflash.
Using a Single Line Telephone with a call in progress:
To Next Page
Loading...