T - 10 Tone Override
Issue 6 Electra Elite
Restrictions:
Tone Override can be accomplished only after receiving a call waiting
tone.
Tone Override may be denied for the following reasons:
• The Multiline Terminal is set in the Do Not Disturb (DND) mode.
• Auto Redial is activated.
• Station Programming is activated.
• The Multiline Terminal is denied Tone Override.
• Another station is already sending a Tone Override to this
station.
• Account Code Entry is activated.
When Tone Override is used from a Dial Pulse Single Line
Telephone, default Access Code
,
must be changed to a numerical
digit.
Tone Override is allowed only from a Single Line Telephone until the
PBR times out (default: 10 seconds).
General:
One Tone Override at a time can be received at a Multiline Terminal.
This Tone Override is heard over the handset and speaker (when the
receiving party is off-hook with the handset).
When a Multiline Terminal is assigned for Data Line Security, a Tone
Override is not heard over the handset; however, the Tone Override
is sent and heard from the speaker when the Multiline Terminal user
is off-hook with the handset.
To Next Page
Loading...