V - 2 Voice Mail Integration (Analog)
Issue 6 Electra Elite
SERVICE
CONDITIONS
Data Assignment:
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] Function numbers 020~25 to assign the Access Code
for Voice Mail Message set/cancel.
Use Memory Block 4-35 (Voice Mail/SLT Selection) to specify
whether (YS) or not (default: NO) Voice Mail is interfaced with SLT
ports.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the required SLI(4)/(8)-U10 ETU.
A maximum of four SLI(4)-U10 ETUs or two SLI(8)-U10 ETUs can be
installed to support 16 analog Voice Mail ports.
Restrictions:
SLI(4)/(8)-U10 ETU ports assigned as voice mail cannot establish an
Add-On Conference Call.
General:
Some Voice Mail systems cannot leave a message indication.
A call transferred from a Voice Mail port that is not answered in three
minutes recalls to the Voice Mail port. No digits are sent.
When a station is programmed for Multiple Call Forward (e.g., 100
CFWD – 101 CFWD – VM Hunt Group) and an internal call is made
to station 100, the caller receives the mailbox for station 100.
The ADA(2)-W(BK)/(SW) Unit, APR/APA-U Unit, and SLT(1)-U10
ADP do not support Voice Mail Integration.
Set/cancel Voice Mail Message Waiting only from a Voice Mail port.
When a call is complete, a disconnect signal is sent to the VM port.
For connecting Voice Mail systems, refer to the applicable
Engineering Technical Information (ETI) bulletins.
When required by locally provided Voice Mail systems, up to four
digits can be sent before a station number to access a user mailbox.
The Large LED flashes red for message from Voice Mail or green for
message from an Attendant.
This can be used for Centralized Voice Mail.
To Next Page
Loading...