EasyManua.ls Logo

NEC Electra Elite 48/192 - Page 631

NEC Electra Elite 48/192
652 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
V - 10 Voice Over Internet Protocol (VoIP)
Issue 6 Electra Elite
SYSTEM AVAILABILITY Terminal Type:
All Multiline Terminals
Required Components:
IPT(4)/(8)-U10 ETU
OPERATING
PROCEDURES
SERVICE
CONDITIONS
Data Assignment:
The IPT(4)/(8)-U10 ETU can communicate only with another
IPT(4)/(8)-U10 ETU that may reside on a remote KTS.
General:
Memory Block 1-1-59, (Synchronous Ringing Selection), must be set
to NO when the IPT(4)/(8)-U10 ETU is used as a COI/COIB/COID
ETU.
The LIVE LED flashes when the ETU is receiving power from the
KSU.
Two LEDs on the RJ-45 Connector indicate the Ethernet status. A
yellow LED indicates the Ethernet Link is up, and a blinking green
LED indicates activity.
Eight STATUS LEDs are provided to indicate the status of an
associated trunk or channel when COID or DID mode is selected.
Indications are as follows:
Use any combination of manual dialing, Save and Repeat, Save
and Store, Last Number Redial, Station Speed Dial, and System
Speed Dial.
Trunk Status LED for COID LED for DID
Not installed Off Off
Idle Off Off
Incoming Off On
Busy On On

Table of Contents

Related product manuals