V - 18 Voice Prompt
Issue 6 Electra Elite
1. Go off-hook.
2. Dial the VRS voice message record/verify/erase Access Code.
3. Dial operation:
A
Recording
B
Confirmation
C
Erasing
4. Dial operation:
B
Voice Prompt Message
5. Dial operation:
A
Message for Dial Tone
B
Message for Call Waiting Tone
6. Record message.
7. Go on-hook.
Note: During Message Recording, the LCD indicates the time remaining for recording
the message.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Blocks 1-1-46~48 [Access Code (1-, 2-, or 3-Digit)
Assignment] (default: code 501) to assign terminals in Station Class
of Service to retrieve, confirm, or clear VRS messages.
Use Memory Block 1-8-12 (VRS Message Recording Time Selection)
to specify the number of messages (default: 16) and the recording
time (default: 15 sec.) for each message.
Use Memory Block 1-8-13 (VRS Message Function Assignment) to
assign each station to receive Voice Prompt messages.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the necessary VRS(4)-U10 ETU.
Restrictions:
A maximum of two VRS(4)-U10 ETUs can be installed in an Electra
Elite 48/192 system for 8 voice playback channels.
To record a Voice Prompt message:
To Next Page
Loading...