A - 72 Automatic Redial
Issue 6 Electra Elite
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-04 (Automatic Redial Time Selection) to
program Automatic Redial Time parameters as follows:
Restrictions:
The station retains sole use of the outside line during Automatic
Redial.
An internal call received during Automatic Redial cannot be
answered unless Automatic Redial is released. The calling station
receives a call waiting tone.
A station user cannot set a Tone Override to a station with an
Automatic Redial set. However, a Callback Request or an Automatic
Callback can be set.
This feature is not available for Single Line Telephones.
This feature is not available for Tie/DID lines.
General:
This feature remains in effect until the party initiating the call lifts and
restores the handset or presses Speaker during a redial attempt, an
incoming call is answered on that line, or two (default) redial attempts
are made.
The system does not detect answer, no answer, or busy condition
from the outside network.
When Automatic Redial is in progress (a call is being initiated by the
system), an LCD appearance (
,
: Number Dialed) confirms Automatic
Redial is activated. For stations with or without an LCD, a flashing
Feature LED indication is provided, and the Redial key is on
continuously.
The outside line LED on the Multiline Terminal, where Automatic
Redial is initiated, is green but on other Multiline Terminals in the
system it is red.
When the feature times out, access a CO/PBX line, press the
Feature key and then the Redial key, or a Feature Access or One-
Touch key programmed for this feature, to reactivate it.
Programming Range Default
Callback Time: 1~50 seconds 030
Wait Time: 1~100 seconds 060
Redial Times: 1~ 15 times 002
To Next Page
Loading...