A - 78 Automatic Route Selection (ARS)
Issue 6 Electra Elite
Restrictions
Route Advance Blocks or Trunks programmed on a line key, bypass
ARS.
ARS is not available when the Electra Elite 48/192 system is in KF
registration.
Outgoing calls using Direct Inward System Access (DISA) cannot
access ARS.
ARS cannot be used to route calls by hour of day or day of week.
Only a single Route Assignment can be specified for each Dialing
Assignment entry.
When ARS is set to YES (allow) using Memory Block 1-14-00 (ARS
Allow/Deny Selection), the MIFM LCR is disabled even when
allowed in system programming.
A maximum of 10 digits can be deleted or added to a Route
Assignment.
General:
All Trunk Groups in the system (00 is used to deselect trunk groups)
can be accessed using ARS.
Trunk Group Access code 9 (default) activates ARS at stations
assigned for LCR Class assignment using Memory Block 4-40 (LCR
Class Selection).
ARS is based on actual digits dialed to properly route the call.
ARS can be programmed to consider a maximum of eight dialed
digits before making a selection for the number dialed.
When using Code Restriction with ARS, code restriction applies to
the digits dialed by the station user.
After an interdigit time of 10 seconds expires during dialing using
ARS, a busy tone is generated, and the user must redial the number.
When a station user places an outgoing call using ARS, Trunk
queuing cannot be set.
When a feature code is assigned to CO Feature Service code for
Code Restriction using Memory Block 1-1-82 (CO Feature Code
Service for Code Restriction), this code does not have to be
programmed in the ARS Dialing Assignment Tables.
When ARS route assignment 00 is set using Memory Block 1-14-03
(ARS Route Table Number Assignment), the dialed number is sent
out Trunk Group 01 the way the number was dialed.
To Next Page
Loading...