Item
No.
Item Input Data Description Default Related
Program
05 Transfer Key Op-
eration Mode
0 = Transfer
1 = Serial Call (call
back)
2 = Flash
Use this option to set the operating
mode of the extension Transfer key.
The keys can be for Call Transfer,
Serial Calling or Flash. When select-
ing the Flash option (selection 2),
refer also to Program 81-01-14.
0
06 Hold Key Operat-
ing Mode
0 = Normal (Common)
1 = Exclusive Hold
Use this option to set the function of
the Multiline Hold key. The Hold key
can activate normal Hold or Exclu-
sive Hold.
0
07 Automatic Hold
for CO Lines
0 = Hold
1 = Disconnect (Cut)
When talking on a CO call and an-
other CO line key is pressed, the
original trunk is placed on Hold (0)
or Disconnected (1).
1
08 Automatic
Handsfree
0 = Preselect
1 = One-Touch (Auto-
matic Handsfree)
Use this option to set whether
pressing a key access a One-Touch
Key or if it preselects the key.
1
09 Auto answer to
incoming call
from Extension
0 = Off
1 = On
1
10 Ringing Line
Preference for
Trunk Calls
0 = Idle (Off)
1 = Ringing (On)
Use this option to select between
Idle and Ringing Line Preference for
trunk calls.
1
11 Callback Auto-
matic Answer
0 = Off
1 = On
Use this option to enable or disable
automatic answer of calls recalling
to a station. For example, if a Trans-
fer Recall or Hold Recall is ringing
back to a station, the following hap-
pens:
If Program 15-02-11 is enabled, the
station will automatically answer the
recall when it goes off-hook. If Pro-
gram 15-02-11 is disabled, a station
does not automatically answer the
recall when it goes off-hook. The
user must first press the line ap-
pearance of the recalling call or
press the answer key.
1
12 Off-Hook Ringing 0 = Muted Off-Hook
Ringing
1 = No Off-Hook Ring-
ing
3 = Beep in Speaker
(SP)
4 = Beep in Handset
(HS)
5 = Speaker and Hand-
set Beep
Use this option to set the telephone
Off-hook signaling. Off-hook signal-
ing occurs when a telephone user
receives a second call while busy on
a handset call. To enable/disable
Off-hook signaling for an extension
Class of Service, use Program
20-13-06.
5
13 Redial List Mode 0 = ICM/Trunk (Exten-
sion/Trunk Mode)
1 = Trunk Mode
Select whether the Redial List fea-
ture should store internal and exter-
nal numbers (0), or only external
numbers (1).
0
15 Storage of Call-
er-ID for an-
swered call
0 = Disable (Off)
1 = Enable (On)
1
16 Handsfree Oper-
ation
0 = Disable (Off)
1 = Enable (On)
Enable or disable an extension abili-
ty to use the speakerphone on out-
side calls. When disabled, users can
hear the conversation, but cannot
respond handsfree.
1
18 Power-Saving
Mode
0 = Normal mode
1 = Power-Saving
Mode (Eco-Mode)
1
ISSUE 6.0 SL1100
Programming Manual 2-129
Program
15
To Next Page
Loading...
